Regarding the maintenance of Conical Screw Barrel :
1.
When the new machine is used for half a year, due to wear, the clearance between the screw and the barrel must be checked every three months, and appropriate adjustments must be made. This is done to avoid excessive clearance leading to a decrease in output, and it may even be the result of screw fracture due to excessive screw swing angle.
2.
The gap between the screw and the barrel is directly related to the quality of the product. If the gap is too large, the shear rate will be low and the plasticizing effect will be poor. Severe material reflux will not only reduce the output, but also make the material stay longer in the barrel and burn easily. If the gap is too small, the shear rate is too large, the material is also easy to scorch, and the screw may even scratch the barrel. Therefore, the gap between the screw and the barrel cannot be too large or too small.
3.
Before measuring the gap between the screw and the barrel, the residual material in the barrel must be removed, and the screw shaft should be close to the distribution box. As shown in the figure below, use a feeler gauge to measure the gap at points A and B. A reasonable gap (marked with T) should be between 0.20 and 0.30 mm. The following steps are about how to adjust the clearance of the conical twin-screw barrel.
For more detailed information on how to install the conical twin screw and barrel, and how to adjust the gap between the screw and barrel, please contact us in time. Or if you want to know about Injection Molding Screw Barrel , or if you have any other questions, you can also contact us in time.
